Hollow Penis Extender UAE - 16 cm Girth Sleeve, 94 g

Five centimetres is the number this extender is sold on, and the supplier prints it in a Before and After panel on the pack. Read that panel as a shape rather than as a promise: a hollow sleeve of a given length adds up to that length, minus whatever it covers. Sixteen centimetres total, so most of the stated gain depends on how far the wearer is inside it before the sleeve starts.

Ninety-four grams, sixteen centimetres long, three and a half across. That is a full-size hollow extender rather than a slim textured tube, and the wall is built to hold a cavity open rather than sitting against the surface. The inside is smooth; the outside carries vein detail and a defined glans.

The base is where a hollow sleeve either works or does not. This one has a wide base without a scrotum wrap, so it stops at the root instead of stretching back. A wide stop that does not move is what keeps a hollow sleeve from rolling down mid-use — narrower bases are the ones that end up as a ring around the middle.

There is a second hollow 16 cm sleeve on the same page and the difference is worth knowing before you pick. That one is 17 cm and 85 g with a scrotum base; this is 16 cm and 94 g with a plain wide base. The scrotum base grips harder and covers more; the plain base is quicker to fit and easier to clean.

Fitting is a two-hand job the first time. Roll it on with lubricant on both surfaces, work the air out of the cavity as you go, and check that the base has not curled under before it gets used. Air left inside a hollow sleeve is what makes it feel loose.

Drying is the part people skip and it is the part that decides how long this lasts. A hollow sleeve has two surfaces and only one of them is easy to reach. Roll a dry cloth through the cavity, leave it somewhere with air moving across the opening rather than folded in a drawer, and give it an hour. Material left damp between the walls is where the smell starts, and once it is in a porous moulding it does not come back out with soap.

The outside collects dust in the vein detail. A rinse before use is quicker than scrubbing after, and it saves the surface from being worked over again every time.

Silicone or water-based lubricant only. Wash with warm water and mild soap, then dry the cavity through its full length and not just the opening. Store flat, not folded, and not pressed under anything heavier. Plain unmarked outer packaging.

For anyone who wants added length and a firmer surface with a base that stays where it is put. Not for anyone looking for girth — 3.5 cm across is close to the same width as the sleeve it covers, so the gain is length rather than width. And not for anyone who wants something that transfers sensation through, because a hollow wall of this thickness does not.